Belts on a 3D printer should be tight enough, but not too tight. That can be an iffy thing to get right for someone who lacks familiarity with CNC platforms. Prusa Research aims to make it a bit ...

Timing-belt drives transmit torque and motion from a driving to a driven pulley or force to a linear actuator. They may also convey a load placed on the belt surface. A drive under load develops a ...

The most common reasons for belt failure are improper belt tension (too loose or too tight), poor alignment, pulley damage or distortion, environment (excessive heat and ozone), and using an improper ...

Over-tensioning shortens not only the life of V-belts but also that of the sheaves, electric motor, and driven equipment bearings. In extreme cases, it can even bend or break a motor shaft.

If you have an internal combustion engine that actually runs, then your camshafts are spinning twice as fast as your crankshaft. Change the rate at which either of the two spins in relation to one ...

This is a typical small-block Chevy serpentine-belt drive on the front of a 350. This particular application is a little more complicated because of the Paxton installation, but you can see the belt ...

Frictional belt drives reliably transmit power from source to load without asking much in the way of upkeep. Their modest needs stem from the fact that belts elongate through normal use and wear. The ...